General-machine-products 89910 Whisper Micro Fiber Cable Blowing Machine Manuel d'utilisateur télécharger pdf (Page 17)

Page 17

General Machine Products Co., Inc.

NOTE: THE MACHINE MUST NOT BE SUBMERGED IN WATER.

Installing Cable

Speed Distance indicator:

This device will measure and display the distance traveled by the cable and also the speed at

which the cable is traveling. The functions are controlled by the small green push button on

the right of the display. If this button is depressed twice, the display will “toggle” between

speed and distance. Pressing the red button will reset the display to zero. Before starting an

installation, it will be necessary to depress the red button to set the distance display to zero.

Should it be necessary to replace the speed distance measuring indicator, it will be necessary

to reprogram it.

To install cable:

1. Attach drill to Whisper drive motor shaft (if not already attached) and tighten drill

chuck. Be sure that the drill is set in the forward or clockwise rotation setting and low speed.

2. Set drill torque setting starting at the minimum and work your way up.

3. Start air compressor and open air output valve, or if using nitrogen open the tank output

valve to full flow. Keep the valve on the Whisper closed.

4. Activate cordless drill to desired speed and monitor distance and speed with the counter.

Average installation speeds are between 150-300 FPM. It is sometimes necessary to gently

hand assist the fiber cable into the cartridge to initiate forward motion. (Do Not Bend or Over

Stress the cable.) When approximately 150’ of cable is installed, gradually open the air valve

on the Whisper

5. When cable exits duct end, take the desired amount of slack, stop drill and turn off air valve

and allow it to vent all the residual air before opening airbox.

6. Turn the power off on the counter to preserve battery life when not in use.

Caution: If during the installation, the cable hits an obstruction and stops, immediately

stop the drill. Continuing could severely damage the cable.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Pas de commentaire

General-machine-products 89910 Whisper Micro Fiber Cable Blowing Machine Manuel d'utilisateur Page 17